Article number: 10702
LIMONENE is the perfect solvent for anyone wanting to print support heavy multi extrusion 3D models who does not want to spend hours having to manually remove , non dissolvable, support structures. The limonene will initially soften the hips and over time dissolve the material completely leaving nothing but a sticky sludge that is easy to clean off with a brush and hot water.
Dissolvent for HIPS (not ABS)
Packed & labeled according to EU regulations
R38- Irritating to skin.
R43- May cause sensitization by skin contact.
R50/53- Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
S03- Keep in a cool place.
S16- Keep away from sources of ignition - No smoking.
S24- Avoid contact with skin.
S37- Wear suitable gloves.
S60- This material and its container must be disposed of as hazardous waste.
S61- Avoid release to the environment. Refer to special instructions/Safety data sheets.
S62- If swallowed, do not induce vomiting: seek medical advice